The steps to configure the Mico DTH play box is as follows;
1. Firstly you need to change the Low Noise Block (LNB) settings.
When you turn on the play box the "Guide" menu will appear. Using the remote for the play box , navigate to Media Play and press OK.
2. Scroll down to "Setting" and press the right arrow key and scroll up to "Search" and press "OK" button to select.
You will see that Satellite List will appear with JCSat as Satellite 01 and highlighted with the satellite settings on the right hand side of the screen. The Default settings are as follows;
-
- LNB Type: 10700
- LNB Power: 13/18V
- 22KHz : Auto
- Toneburst: None
- DISEqC1.0 : None
- DISEq1.1 : None
- Motor : None
3. Press right arrow key and the LNB type and list of LNB frequencies will appear.
4. Change LNB type according to the hardware.
Note: White LNB hardware uses LNB type 10700. Black and White LNB hardware uses LNB type 09750/10600.
Once appropriate LNB type is selected then press "OK" button.
5. Press "EXIT" and the JCSat01 will be highlighted again.
6. Press "OK" and all transponders will appear including signal Strength and Quality reading from which dish alignment can be confirmed.
7. To perform a channel scan:
You can press the Red button (TV/Radio) on the play box remote control while you are on the TP List page. The channel scan window will pop-up, scroll down to Confirm and press OK, then scanning process will start and save automatically.
To find out more, please chat with us by clicking here or send us an email CustomerCarePNG@digicelpacific.com or go to our Digicel PNG official Facebook page by clicking here: DigicelPNG Facebook. Our operating hours are from 8am to 9pm every day.