Here is a step by step on how to configure your DTH (Direct-To-Home)
- Steps
1. Press “Menu” on remote
2. Navigate to “Settings”
3. Select “Channel search” and press “OK” on the remote - Highlight 003 012.4E Ku_JCSAT 4B from the list of satellites.
- Press the OPT button to add a transponder.
- Next screen will show transponder highlighted
Adding Transponders
Since the launching of the new TV Plans, DTH Play boxes are now using 4 Transponders. Viewers must key in these 4 Transponders to enable viewing of additional channels upgraded to the new plans/ TV list.
Below are the new Transponders and steps to add them to the 2 existing ones.
Adding Old Transponders
Press the RED button then key in 121014 using the number buttons to enable editing
(You will not see any changes on the screen, but the STB is accepting the key password to). Make changes. Then Press the RED button again.
- a. Transponder: (Old transponder)
- b. Frequency: Key in 12322 using the number buttons.
- c. Symbol Rate: Key in 15000 using the number buttons.
- d. Polarity: H.
- Press OK to save changes.
Press the RED button.
- a. Transponder: (Old transponder)
- b. Frequency: Key in 12340 using the number buttons.
- c. Symbol Rate: Key in 15000 using the number buttons.
- d. Polarity: H.
- Press OK to save changes.
Adding New Transponders
The RED button enable two additional transponder editing, hence, after entering the 2nd transponder, you will have to press the RED button for the 3rd time and this time key in the code 121014 and then press the RED button once again.
- a. Transponder: (New transponder)
- b. Frequency: Key in 12282 using the number buttons.
- c. Symbol Rate: Key in 15000 using the number buttons.
- d. Polarity: H.
- Press OK to save changes.
Press the RED button.
- a. Transponder: (New transponder)
- b. Frequency: Key in 12300 using the number buttons.
- c. Symbol Rate: Key in 15000 using the number buttons.
- d. Polarity: H
- Press OK to save changes.
Note: Should DTH viewers already have the 2 old transponders: 12322 H 15000 & 12340 H 15000
All they have to do is:
Press the RED button then key in 121014 using the number buttons to enable editing
(You will not see any changes on the screen, but the play box is accepting the key password to) and then press the RED button again. Add transponders:
- 12282 H 15000
- 12300 H 15000
Once these two transponder are added and signal is confirmed above 50% steady then press the blue button on the remote to initiate the searching.
However if all four (4) transponders are available, press OK on each transponder to select and ensure signal for strenght and quality are above 50%. Then press the blue button to start search.
To find out more, please chat with us by clicking here or send us an email CustomerCarePNG@digicelpacific.com or go to our Digicel PNG official Facebook page by clicking here: DigicelPNG Facebook. Our operating hours are from 8am to 9pm every day.